Results 1 to 10 of 10
  1. AKay's Avatar
    Posts
    50 Posts
    Global Posts
    65 Global Posts
       #1  
    anyone know of any good VPN software for the TREO?
    I tried Anthavpn and i cannot browse anything once i connect.
    Thier support is 100 percent over email and they never get back to me.

    I need to be able to vpn into my companies network first and foremost. So i can dial into servers or machines via Remote Desktop.
    Thanks in advance for any help/reccomendations.
    AKay
  2. naivete's Avatar
    Posts
    636 Posts
    Global Posts
    640 Global Posts
    #2  
    There's Mergic (PPTP) and Movian (IP-Sec). I don't know if Movian is still in business anymore. Search and you should find something on them.
  3. AKay's Avatar
    Posts
    50 Posts
    Global Posts
    65 Global Posts
       #3  
    still searching but the wierd error i get with ANTHA is IPCOMP not supported.
    Is the problem with my VPN or the Antha software?
    AKay
  4. naivete's Avatar
    Posts
    636 Posts
    Global Posts
    640 Global Posts
    #4  
    It's probably because your company is using IPCOMP and your client doesn't support it. You might want to check out SoftRemote.

    http://www.safenet-inc.com/products/vpn/softRemote.asp
  5. #5  
    I am using the NCP Secure Entry Client to connect to a Cisco PIX using IPSEC. Works well.
  6. AKay's Avatar
    Posts
    50 Posts
    Global Posts
    65 Global Posts
       #6  
    hmmm im going to try that one in a few.
    Thanks!
    AKay
  7. AKay's Avatar
    Posts
    50 Posts
    Global Posts
    65 Global Posts
       #7  
    Hey ITS ALL GOOD i downloaded and installed it how do you configure the settings?
    ALl it did was start a service.
    AKay
  8. #8  
    You need to configure it from your PC, then push the settings to the Treo. They have configuration documentation for a few VPN gateways. Once you have the config on your Treo disconnect from your PC and ActiveSync, or it will attempt to use your PC as it's network connection. On the Treo, go to Prgrams-NCP Client Service, Run it. You can watch the connection with the Client Monitor. You won't need to use the Client monitor to initiate a session once the Client Service is running.
  9. AKay's Avatar
    Posts
    50 Posts
    Global Posts
    65 Global Posts
       #9  
    holy shyt i dont know if it was this software or my data cable but i cant use active sync anymore!!!!
    Oh man i think the cable went bad! im going to have to pick another one up tomorow
    AKay
  10. AKay's Avatar
    Posts
    50 Posts
    Global Posts
    65 Global Posts
       #10  
    http://www.bluefiresecurity.com/

    BAM!!
    I finally found an excellent VPN solution for me.
    This program works awesome with the treo700w.
    It allowed me to connect to my companies Cisco concentrator with IP compression no problemas!!!
    Its a full 30 day trial not a timer so I was able to test fully and its awesome.
    Im going to buy the license its 80 bucks but for me well worth it.
    AKay

Posting Permissions