Results 1 to 2 of 2
  1.    #1  
    I have a client that I attempted to upgrade his Treo to 1.12. Followed the instructions very close. The initial hot sync went well and the Treo started updating itself. Once it was done, we went through the initial calibration, etc. and then performed a hot sync. After the hot sync occurred, the Treo started updating itself to 1.12 (Again!). This has happened 3 times.

    I have made sure there is nothing in the installer program to install on the next hot sync. What should I try?

    Bryan

Posting Permissions