Hello, I'm from Vietnam. I recently purchased Verizon branded Treo 600 CDMA from eBay. I decided to buy this device because I liked its quality so much but i didn't know how difficult to re-program it....... please help ....

Following is my Treo's info:

-software rev : Treo600-1.03-VZW
-hardware rev: C
-PRL version : 50174
-PRI check sum : 0x11EC
-Reburb status : No
-Reburb provider: PMO



I brought my Treo to a provider's center and got an answer that they can't re-program it (.....My Treo 600 was the first Treo they had ever seen)

I had to spend hours on several forums and and at last i got an Activating code and MSL number (#*#000000) that helps me to change MDN (Phone number), MIN, SID (system ID), NID ( network ID). I brought this phone to Vietnam CDMA provider's service centre and was told that they need NAM ( Number assigned memory) code(s) to set PCH ( primiary chanel? ), SCH ( sub Chanel?), system band ( A band, B band, standard), MCC, MNC....

Now when i punched debug code ( #*#33284 ) and got followed "debug prameters" board:
-RSSI Value -105
-CP state Invalid State 000
-SID,NID 0,0
-RF Mode,CH# Slepp,525 (Earlier, it kept turning 800 to 1900Hz..)
-P_REV_IN_USE 6
-SO,F-RC,R-RC 0,0,0
-Active PN, Ec/Lo 0--63
-Rx,Tx,T x Adj -105,--52,--63
-FCH Walsh Code 0000 FFFF FFFF FFFF FFFF FFFF
-Finger PNs 0,0,0,0
-Finger Rx -0,-0,-0,-0
-Finger lock State N,N,N,N
-Bad Frames 0
-Total Frames 0
-FER 0.00%

Any one knows about NAM codes/ NAM setting method for Treo 600 CDMA to set it into Vietnam 800 Hz CDMA network, Please help.....Thanks and looking forward to hearing from you soon.