Results 1 to 3 of 3
  1.    #1  
    Hi,

    i've updated from 2.05 to 3.04 (GSM unlocked).

    Then i'am locking for the firmware the 2.05 is still in the display?

    What can i do?

    After the update i haven't run a hotsync up to now! Is this the reason?

    Cu,
    Pit from germany
  2. #2  
    hello pitspit!
    you need to folow this:
    Method A - for any GSM Treo 600 that has INT firmware (i.e. it is unbranded).


    Download the V3.04 firmware aka Crow 112 Updater (Crow_112_Updater.zip) to your computer
    Make a backup of your Treo (HotSync or use a backup application)
    Perform a hard reset.
    Leave the power plugged in to your Treo, turn wireless mode off.
    Unzip the file and copy the Crow_1.12_Updater.prc onto your SD card.
    Insert the SD card in the Treo. On the Treo, go to the applications list (the home button), go to the last category (the SD card), and run the application that is there called "Crow 1.12".
    Let the Crow do his stuff, then see below.

    Method B - for GSM Treo 600 phones that are locked. This method will also unlock your phone.

    Part 1:

    Download the V3.04 firmware aka Crow 112 Updater from the downlaods section onto your computer. (Crow_112_Updater.zip)

    Also download the patched V2.12 firmware (cingular1_11_patched.zip)

    Unzip the Crow 112 Updater and HotSync Crow_1.12_Updater.prc to your SD card.

    Backup your Treo 600.

    Do a hard reset.

    Connect your Treo to the mains power supply.

    Install the SD card and run 'Crow 1.12'
    Part 2:
    Clear the Crow 1.12 Updater from your SD card.

    Unzip the patched Cingular 1.11 firmware and transfer all the files to your SD card.

    Install the SD card and run the 'firmwareupgrade' file ONLY.

    When complete, remove the SD card.

    Turn on phone and check 'Phone Info' you will have FW 2.12 and SW 1.12.

    Your phone should be unlocked, too.

    Good luck
  3.    #3  
    Hi Forrest,

    i've performed the way "A"

    After 20 seconds it was ready with the update. After that i'll made a hardreset.

    ..."Then i'am locking for the firmware the 2.05 is still in the display?"

    Have i to do a hotsync after the update?

    Thx, Pit

Posting Permissions