Results 1 to 3 of 3
  1.    #1  
    Whenever I try to beam something to another Palm, my Treo 600 returns the error: "Could not initialize library."

    Anyone have any idea what might be wrong, or a way to fix it short of doing a hard reset?

    Thanks,
    Bob Meyer
    I'm out of my mind. But feel free to leave a message.
  2. #2  
    you are probably using the add-on keyboard. your treo can only use one serial port at a time. disable the keyboard drivers (instructions in manual), and you should be able to beam just fine.
    this has been discussed here before.
  3.    #3  
    Actually, I didn't have the keyboard driver installed. I DID have it at one point, but had deleted it.

    So I re-installed it, enabled and then disabled it, and now beaming works again. Wierd.

    Thanks, by the way.
    Last edited by meyerweb; 01/25/2004 at 04:52 PM.
    Bob Meyer
    I'm out of my mind. But feel free to leave a message.

Posting Permissions