Results 1 to 4 of 4
  1.    #1  
    Everytime I turn on my Palm V, I get this message:

    "Fatal Error"
    "init.c,Line:268,No serial library"
    "reset"

    I've tried numerous resets (hard and soft) but to no avail...

    Any suggestions?
  2. #2  
    I'm not an expert, but it would seem that some program or hack is corrupted, and a hard reset will only restore the problem when you re-sync.

    Did you try a warm reset? If you warm reset - you may be able to get the unit running and then disable all hacks or delete the program you think may be causing the problem. Then soft-reset, and it should be OK.

    Or, you might try looking at your backup folder, and removing any .prc's that access the serial port (don't delete them - move them to another folder) Then do a hard reset, and re-sync. If the problem goes away, then you can reinstall the .prc's one-by-one.

    Michael
  3. #3  
    Originally posted by cmrj1164
    Everytime I turn on my Palm V, I get this message:

    "Fatal Error"
    "init.c,Line:268,No serial library"
    "reset"

    I've tried numerous resets (hard and soft) but to no avail...

    Any suggestions?
    Sure, get rid of the Palm V and buy a Treo 270/300.
  4. #4  
    Originally posted by Maniac8888


    Sure, get rid of the Palm V and buy a Treo 270/300.
    Good answer!!!

Posting Permissions