Results 1 to 2 of 2
  1.    #1  
    I just replaced my sons beat up housing on his At&T 680 with a brand new one. The touch screen and keypad works fine but I can’t get a signal. It just says phone is “Phone Off” then goes to no service when I try to make a call. I took it apart a few more time but I can’t tell what I did wrong. Any clues on what I should check or do next? Thanks
  2. mlynch53's Avatar
    Posts
    25 Posts
    Global Posts
    30 Global Posts
    #2  
    When I bought a new case for my A T & T 680, I had to re-open it a couple of times and re-set the tiny cable connections. It can be a bit tough to insure all the pins and wires are connecting! I don't know that this is your problem, but you might try that!

    Mike

Posting Permissions